(Step 1) Connect your DAW to the Hornet via standard MIDI cable.
Set the Input Channel 1 knob at 7.
Set OSC 1 to around 4.

(Step 2) Now patch the following pins at the matrix:
A 15 and C 15, I 11 and D 3. (pic 1.1).
Make sure that the EG repeat knob is set to 10 (off position). f.e. EG settings 0, 0, 0, 10, 0, 10.

(Step 3) Now play/hold a bottom C (MIDI Note No. 48, C3, 130Hz) on your DAW or keyboard and use another software-instrument or synth to tune the Hornet to bottom C. Adjust OSC 1 via vernier to bottom C.

(Step 4) Then play C an octave up and adjust Input Channel 1 for 1V/oct. Re-check on 2..3..4..5 octaves.

Note. If you insert more pins to the matrix the Hornet may go out of tune because the matrix is not buffered. In this case you plain need to redo (Step 4) again.

If the Hornet Midi Interface do not get any notes or shows any tuning faults. Please follow these steps:
Download this pre-configured file or configure your own at midimplant.com
Send this file via DAW to the Midi Interface and repeat procedure above.

(pic 1.1)

midi_calib